Issue with conveyor side transfer

Question

question

ShabDz asked Nov 13, '18 ShabDz commented Nov 14, '18

Issue with conveyor side transfer

Hello all,

Something very strange occasionally happens to the attached model: the Conveyor Transfer put the boxes INSIDE the next conveyor, instead of putting them ON the next conveyor. Anyone knows what's the problem?

Thanks in advance

test-side-transfer-autosave.fsm

Software Version:

FlexSim 18.2.2

conveyor system conveyor transfer side transfers

capture.jpg (47.3 KiB)

test-side-transfer-autosave.fsm (181.6 KiB)

· 2

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

Joshua S commented · Nov 13, 2018 at 07:27 PM

@ShabDz

Can you upload your model so we can see how it is all connected, this will allow us to better answer you question and see what is occuring.

1 ·

ShabDz Joshua S commented · Nov 13, 2018 at 08:14 PM

Thanks. I attached the model.

0 ·

Answer 1 · 2018-11-13T21:18:46Z

Joshua S answered Nov 13, '18 ShabDz commented Nov 14, '18

Double Click on one of your transfer points between your ramp conveyors and your 17_5A conveyor then open up the properties for the Transfer Type and change the Transfer Time to "Motion-Aligned Conveyor Speed". This fixed the issue and there was no noticeable change to the process.

· 1

5 |100000

Attachments: Up to 12 attachments (including images) can be used with a maximum of 23.8 MiB each and 47.7 MiB total.

ShabDz commented · Nov 14, 2018 at 03:55 PM

Thank you @Joshua S

0 ·

question